How to change the chip yourself in the music center

With the help of music centers you can listen to your favorite songs, organize concerts and spend holidays. To do this, you must correctly connect the equipment, make settings and start the selected audio recordings. To familiarize yourself with the possibilities of technology, you should read the instructions and instruction manual. There you can find answers to all questions.

However, sometimes during operation there may be malfunctions that lead to distortion of sound and poor quality. In this case, it is necessary to repair or replace the components. One of the most important design details is the microcircuit integrated into the product body. It is she who ensures the correct operation of the entire system. How to change the chip yourself?

If you have a need to repair or replace the microcircuit in the equipment, first you need to properly disassemble the device to gain access to the necessary element. To do this, follow these steps:

1. Take a flathead screwdriver and material on hand for convenience.
2. Unscrew the outer case sheets on the sides and bottom. Then remove the cover.
3. Now you will have access to the internal parts of the device. Using a screwdriver, unscrew all retaining bolts to gain access to the central part.
4. Find the chip you are interested in from a wide variety of wires and sensors.
5. Gently pry its edges with tweezers or a knife. Be careful not to damage the body of the part. If it is broken, you can just pull it out of the slot for further replacement.

Important! In some cases, the parts can be reliably soldered, a strong mechanical effect is required to remove the elements.

How to replace the chip: instructions

After gaining access to the main element, you can begin to replace. This is quite simple to do, following all the steps in the instructions:

1. Mark with a marker the attachment points of all sensors and terminals.
2. Disconnect the old chip from the case using a soldering iron in the hot air mode.
3. Insert the new item according to the notes.
4. Using a blowtorch, reinstall everything.
5. Perform a test run of the system to assess the quality of work.