Infrared laminate flooring pros and cons

Laminate flooring is a very cold floor. To improve the situation, you can use infrared floors under it. This will allow you to refuse additional heating. However, you should understand the positive and negative aspects of such a decision.

A similar product has a film base and becomes a good competitor for other types of underfloor heating. Prior to its implementation, a lot of concrete work is not required. An infrared product consists of several layers, each of which performs a specific function.

Is it possible to lay the IR floor under the laminate

It is allowed to lay IR under the laminate. It is important to remember that high temperatures negatively affect the coating. Therefore, with the installation of a warm floor, you must act carefully.

Important! Laminate must not be overheated. This will ruin him and he will become worthless.

A water or electric heating system is not suitable due to a strong increase in temperature. This provokes deformation of the floor. It is also important to avoid sudden temperature fluctuations. Because the IR product is more suitable. It helps to distribute heat evenly throughout the area. If the installation of the system is carried out correctly, then the radiation will not be transmitted to the draft base with a film. This will allow the rational use of heat.

Technologies for laying IR floor under the laminate

It is important to carry out installation correctly so as not to spoil the floor covering as a whole. To begin with, it is recommended to draw up a plan of the location of the heating elements. Consider important points will allow a special sketch, which must be drawn up taking into account the following requirements:

1. The film is laid along the room to reduce the number of joints;
2. Cut the product into smaller parts only by special contours;
3. It is necessary to retreat from heating and walls about 25 cm;
4. Do not place heating elements under massive, heavy furniture;
5. Nearby elements should be approximately 5 cm apart.

The sketch should also note the cable connection diagram. In conclusion, determine the location of the temperature sensor. It’s better to choose the coldest part of the room for him.
Before starting installation, you should carefully prepare the base, cleaning it from dirt and dust. Coat the concrete base with heat-reflecting material with foil up. This will eliminate the heating screeds.
Relying on the drawn up schemes, it is necessary to cut and lay the film.

Important! Accidental cuts and damage to the learning and conductive parts should be avoided.

Installation of the product is a copper strip down. For gluing, just use tape. Contact clips must be loaded so that one part is below and the other remains below the surface of the film. After you need to compress the clip with pliers. Cable routing is recommended to be carried out strictly according to the scheme. At the end, a temperature sensor is installed. For fastening, you can use bitumen tape.

Pros and cons of the infrared floor under the laminate

Advantages of IR flooring:

• Easy installation. No concrete screed required;
• It is possible to lay in an already renovated room;
• The accelerated and uniform heating;
• The product can overlook various cares and does not take up much space, preserving more usable area;
• It is not necessary to dismantle the heating system;
• Resistance to corrosion;
• Long service life;
• The ability to connect IR to the smart home system.

Among the minuses include:

• You will need to buy a web browser of high cost;
• The formation of an ideal plane is required to ensure film integrity;
• Possible installation problems in rooms with high humidity.

The listed cons are not critical. The infrared floor is a good laminate floor to provide heat.